![]() Lastly, is there enough heat coming from the battery itself to be worth finding or modifying a heatsink to stick on the half/side away from and not directly under the lens? Would it be possible to perhaps modify the 25x25x10 heatsink by shortening the fins closest to the lens progressively so they don’t show in the image capture? Same question as Maha Mousa, how much of the heat sink was showing in the 360 mod with it on the front face/same surface as the lens? Could you have possibly used a shorter heatsink without compromising too much on it’s effectiveness? Found 14x14圆mm but not 25x25圆 or 7 or ? to make it short enough? So having the traditional configuration with the mounting bracket for additional stability and keeping it as rainproof as possible is also going to be important. Very interested in getting an Insta360 One R 360 and a 1-inch to do some long (multiple hour) continuous documentation of trails (running & hiking). Reviewed here.Īloha Mic Ty, Thanks for this post. vertical battery (around $49) – direct from Insta360.128GB Sandisk Extreme Pro card (around $35).thermal tape (matches the heat sink width, around $11).Or you can get this longer heat sink that could extend beyond the frame of the One R but still be invisible. heat sink or this one (fits the core rear, or side when used with vertical battery, around $10 for 10 pcs).Insta360 One R ( $479 with 360 mod and 4K mod, direct from Insta360, or Amazon, or B&H Photo).Thank you very much for using these affiliate links to support 360 Rumors at no additional cost to you so I can do more tests and reviews. The tape is not reusable, but if you get a roll of tape, you’ll have plenty of tape to reinstall as often as you would want. The tape I got is easy to remove in one piece and leaves no residue. Insta360 One R records over 3 hours 5.7K 360 videoĬan you remove the heat sink? Yes, easily. I should also note that the vertical battery still had a full charge afterward. By the way, there was zero drifting, and no change to the sharpness of the video. The One R created six 30 minute videos with around a 2 second gap between each video. The camera did not turn itself off but it was hot. With a 128GB Sandisk Extreme Pro card, the camera stopped recording because it ran out of space. 360 mod + vertical battery with USB power (charging while recording): 3 hours 4 seconds.The first 30 minutes was one video, then it created a new video, with around a 2 second gap between them. The camera ran out of battery (when I tried to start another recording, it said low battery and shut itself down). Stopped recording but did not turn itself off. 360 mod + vertical battery: 46 mins, 44 seconds.Will not show up in the video even in POV+ and Flowstate turned off. 4K mod: 1 hour, 18 minutes, 6 seconds.The heat sink will not appear in the video even in Ultrawide setting. This was even longer than the time The camera turned off by itself. I set the camera to screen auto sleep on, and I used the Sandisk Extreme Pro Micro SD. My tests were indoors at around 72F with no air conditioning and no fan. The double sided thermal tape I used left no residue. It is possible to attach another heat sink to the top of the 360 mod and to the other side of the 360 mod as well (both are flat surfaces). Unlike the 1-inch mod, I could not attach the heat sink to the back of the core unit otherwise it would be visible to the 360 mod, so I placed it beside the core (the side with the standard battery interface) and I attached another heat sink to the 360 mod, to draw the heat away from the one attached to the core. For the 360 mod, I found it was possible to make the heat sink invisible to the camera when using the vertical battery. I used this heat sink, and this thermal tape. I’ve now tested that heat sink, not just with the 1-inch mod, but also with the 360 mod and the 4K wide mod. Is your Insta360 One R overheating from long videos? I tested out what I call the “mad max mod” and found I could record for up to 3 hours.Ī few weeks ago, I posted how a user was able to increase the recording time for his Insta360 One R 1-inch mod by using a heat sink. ![]() Insta360 One R overheating? Use the Mad Max mod
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |